Multiquip SDW225SS - Manual (Page 25)

SDW-225SS WELDER/GENERATOR — OPERATION & PARTS MANUAL — REV. #2 (10/07/05) — PAGE 25
Figure 13. Securing Stationary Axle and
Caster Wheel Assembly to Cabinet
5. Locate the four bolt holes on the underside of the cabinet
near the front and rear of the machine. Reach into the
cabinet and place a bolt and washer through the cabinet
floor through each hole (Figure 12). A flashlight might be
necessary to find the bolt holes in the cabinet floor.
4. Insert a lifting strap through the lifting eye on top of the
machine and raise the generator/welder off the ground
using a lifting device of adequate capacity (Figure 11).
The generator/welder can be suspended in air while
installing the wheel kit or can be set down on an object
which can support the weight of the machine. Ensure the
bottom of the cabinet has enough clearance to install the
wheel kit.
Figure 11. Lifting Equipment
6. With the stationary axle facing front, lift the axle up so
the bolts in the cabinet floor pass through the bolt holes
on the axle. Place a washer on the bolt under the axle
and secure the axle to the cabinet with a nut (Figure 13).
Figure 12. Inserting Bolts/Washers
SDW-225SS — WKT225A WHEEL KIT ASSEMBLY
7. Center the caster wheel assembly underneath the
machine. Lift the caster wheels up so the bolts in the
cabinet floor pass through the bolt holes on the caster
wheel frame. Place a washer on the bolt under the castor
wheel frame and secure the castor wheels to the cabinet
with a nut (Figure 13).
8. Lower the machine onto the ground and remove the lifting
strap from the lifting eye. The machine should roll freely.
Figure 14. Attaching Handles to Cabinet
9. Near the top of the cabinet on the rear(control panel side)
of the machine, remove the two bolts from the cabinet
wall. Attach the handle to the cabinet wall by inserting a
bolt, lock washer, and flat washer through the bottom
two bolt holes on the handle into the cabinet (Figure 14).
Repeat on the other side of the cabinet.
Lock the caster wheels in place with the attached brake
lever when the generator/welder is not being moved to
prevent the machine from unintentional rolling while in
use.
CAUTI CAUTI CAUTI CAUTI CAUTION