Multiquip SP2S20H20 - Manual (Page 25)

MQ SP2 SLAB SAW — PARTS & OPERATION MANUAL — REV. #7 (09/08/06) — PAGE 25
MQ SP2 SLAB SAW — MANUAL START-UP (13HP HONDA ENGINE)
8. Grasp the starter grip (Figure 24) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.
9. If the engine has started, slowly return the choke lever
(Figure 22) to the CLOSED position. If the engine has not
started repeat steps 1 through 8.
10. Before the saw is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a loose guard and/or covers.
11. All sawing is done at full throttle. Your engine governor has
been set at the factory to ensure an optimum speed setting.
z DO NOT pull the starter rope all the way to the end.
z D
O NOT release the starter rope after pulling. Allow it
to rewind as soon as possible.
Figure 24. Starter Grip
7. Place the throttle lever (Figure 23) halfway between FAST
and SLOW for starting. All sawing is done at full throttle. The
engine governor speed is factory set to ensure optimum
blade operating speeds.
Figure 23. Throttle Lever
CAUTI CAUTI CAUTI CAUTI CAUTION