Multiquip RCC130H - Manual (Page 36)

RCC130H-CRACK SAW OPERATION AND PARTS MANUAL REV #1 (11/18/04) PAGE 36
MAINTENANCE/SERVICE
FIGURE 44.
FIGURE 45
11) Clean the bearing journal areas of the arbor
shaft with an appropriate solvent. Apply a suitable
amount of anaerobic adhesive/sealant to the bearing
journal area located near the snap ring groove.
Press the arbor shaft into the replacement bearing
until it seats itself against the inner race. FIGURE
45.
12) Clean the inside and outside bore of the second
replacement bearing with an appropriate solvent.
Apply a suitable amount of anaerobic
adhesive/sealant to the inside and outside bore.
Install the replacement bearing over the arbor shaft.
Determine that both the inside and outside bores of
the bearing will absorb the thrust from the pressing
process. Press the replacement bearing into the
bearing housing until it seats itself against the
flange. This procedure will minimize the potential for
improper bearing preloading. FIGURE 46.
FIGURE 46
13) Reinstall the snap ring into the snap ring groove
on the arbor shaft.