Setup of the b-10 mobile led, 1 installation of the b-10 mobile led, 2 powering the b-10 mobile led – Barco R9855510 User Manual
Page 25: Installation of the b-10 mobile led, Powering the b-10 mobile led
3. Setup of the B-10 Mobile LED
3. SETUP OF THE B-10 MOBILE LED
Overview
•
Installation of the B-10 Mobile LED
•
•
•
•
•
3.1
Installation of the B-10 Mobile LED
Useful tools
In order to set up the B-10 Mobile LED more easily the following tools may be useful to purchase:
•
A level to verify the flat position of the trailer
•
A drill to position the 4 outriggers and fasten the 2 halves LED display parts together (4 bolts)
How to install?
1. Place the trailer on a flat and hard ground.
2. Unhitch the trailer from the ball hitch. For this purpose, you may need to use the jockey wheel. After using the jockey wheel wind
it fully up to its initial (up) position.
Note:
After using the jockey wheel wind it fully up to its initial (up) position.
Caution:
Only use the jockey wheel to engage and disengage the trailer on & from the towing hook. After usage, always wind
the jockey wheel fully up to avoid damages on the jockey wheel.
Image 3-1
3. Trigger the brake system of the B-10 Mobile LED (back position)
4. Take the wooden plate (in the B-10 Mobile LED left at door entrance) and position them below the outriggers.
5. Start by extending the front stabilizer.
Tip:
If the stabilizers cannot reach the wooden plates, put additional wooden plates under the outriggers.
6. Retract the jockey wheel completely.
Caution:
After using the jockey wheel wind it fully up to its initial (up) position. Only use the jockey wheel to engage and
disengage the trailer on or from the towing hook.
Caution:
A jockey wheel may have a maximum allowed load of 250 kg. Do not use the jockey wheel faulty as it can damage
the wheel and the folding system.
7. Extend the rear stabilizers.
8. Level the B-10 Mobile LED vehicle and try to position it as “flat” as possible in the length and the width. Use therefore a level
and adjust the stabilizers accordingly.
3.2
Powering the B-10 Mobile LED
How to power up?
1. Put the contact in the warm up position. After several seconds turn-on the generator with the contact key.
R5976956 B-10 MOBILE LED 19/06/2007
21