Opticon OPN 2002 v35412 Batch demo Quick Guide - Manual

1
CAUTION: This information is subject to change without prior notice.
Copyright 2010, Opticon Sensors Europe BV, all rights reserved.
This manual may not, in whole or in part, be copied, photocopied, reproduced, translated or converted
to any electronic or machine readable form without prior written consent of Opticon Sensors Europe.
THE GENERAL USE AND FUNCTIONING OF THE BAR CODE SCANNER IS DESCRIBED IN THIS
DOCUMENT. ALSO GENERAL SETUP INSTRUCTIONS TO GET STARTED ARE DESCRIBED IN
THIS DOCUMENT. FOR FURTHER INSTRUCTIONS CONSULT OPTICON OR YOUR LOCAL
DEALER.
OPN2002 & OPN2003 BATCH DEMO MANUAL
(Version RFG35412)
The batch demo application for the OPN2002/3 demonstrates its capabilities to
store barcode data in a file and transmit this file to a remote host. The files are
transferred using the NetO protocol by using USB and/or the CRD2000 multi
cradle.
Since the OPN2002/3 terminals don't have a display to show any instructions
this demo application implements a user interface that consists entirely of using
just the 2 keys to scan barcodes. This brief setup guide describes all features as
well as handling instructions.
More product details, additional support and more configuration options to
customize this application to your own preferences (by using the Universal menu
book) will be updated at
www.opticon.com
Capabilities of the Batch demo application
The following features are currently supported:
Scans and stores barcodes into a database file on the internal RAM disk.
Transmits the barcode data file to a remote PC or laptop using the NetO
protocol by either USB or the CRD2000 multi cradle.
OSE Universal menu book support to configure all barcode decoders, pre-
and suffixes, read modes and various other options.
Storing of configurations in non-volatile memory to allow all settings to be
restored after a reset.
Configurable output format of the database file
Easy software upgrading by USB (VCP) or the CRD-2000 multi cradle
(RS232) using Appload.