Opticon OPN 2002 v35412 Batch demo Quick Guide - Manual (Page 10)

10
Loading software on the OPN2002
To load a new OS or application onto the OPN2002, you'll need a mini-USB cable
(which is supplied with the OPN2002) or the CRD2000 cradle.
To load an OS or application file, please follow the instructions below.
USB Cable Connect the terminal to your PC or laptop using the mini-USB cable
Start Appload and select the (Virtual) COM port of your OPN2002 in
Appload.
Select the OS or application file in Appload using File > Download
Multi Cradle Because not all OS versions support the loading of software on multiple
OPN2002s at the same time, it is recommended to load the software with
only one OPN2002 in the cradle. To do this, follow the instructions below.
Place one OPN2002 in the cradle.
Start Appload and select the COM port of the CRD2000 cradle.
Select the OS or application file in Appload using File > Download.
Wait until the downloading has finished before inserting another
OPN2002 in the cradle.
IMPORTANT (!):
If you have OS version RBGV0207 or higher already installed on your
OPN2002s AND have Appload version 1.39 or higher, then it's also
possible to load software with multiple OPN2002s placed in the CRD2000
cradle.
If you try to load multiple OPN2002s simultaneously with an older version
of either Appload or the OS, then the end result would be OPN2002s with
faulty software that will need to be restored by loading the software again
(one at a time). See the 'trouble shooting' section for more information
about loading software on OPN2002s with faulty or crashing software.
Read the important note above!
Place up to 10 OPN2002s in the cradle.
Start Appload and select the COM port of the CRD2000 cradle.
Select the OS or application file in Appload using File > Download.
To be sure that all OPN2002s have been updated, wait till Appload has
finished downloading the software on all OPN2002s.
Note: The OPN2002 that is currently being updated will be recognizable by
its orange LED, so never remove this OPN2002 from the cradle during the
downloading of the software.
Bluetooth <Currently not supported>
Loading software on the OPN2003
To load a new OS or application onto the OPN2003, you'll need a mini-USB.
Please follow the instructions below.
USB Cable Connect the terminal to your PC or laptop using the mini-USB cable
Start Appload and select the (Virtual) COM port of your OPN2002 in
Appload.
Select the OS or application file in Appload using File > Download