Orbit Baby G3 Toddler Car Seat - Manual (Page 38)

Forwar
d-facing Installation
74
74
Forwar
d-facing Installation
75
75
1. Attach the Side Impact Braces in a
forward-facing position: see pages 71-73.
2. To access the LATCH belt, open the rear
access panel by unclipping the back clip
(Photo A).
3. Remove the LATCH connectors from their
pockets (Photo B). The LATCH belt is
permanently attached to the car seat by a
black strap called the LATCH leash.
If you will be attaching the top tether later
(recommended; refer to page 87), unclip
and remove the tether hook from pocket.
4. For ease of installation, lengthen the
Installing the Car Seat:
With LATCH
Do not use the lower anchors of the
child restraint anchorage system (LATCH
system) to attach the Toddler Car Seat
when restraining a child weighing more
than 40 lbs (18 kg) with the internal
harnesses of the Toddler Car Seat. 1. Un-install the Toddler Car Seat from
your car or have the car seat docked
securely either directly forward- or rear-
facing on the Orbit Stroller.
2. Turn the locking knob on the Side
Impact Brace to the UNLOCKED
position by first pushing it in, then
turning (Photo A).
3. Pull out evenly on both sides of the
brace until the brace rods disengage
completely from the car seat shell
(Photo B).
4. By rotating one brace around, you can
nest the braces together in their storage
position (Photo C). Store braces for
future use in an accessible location. Do
not throw these braces away.
Removing the Side Impact
Braces
back clip
rear access panel
A
B
LATCH connectors
C
A
B
C