Orbit Baby Infant Car Seat and generation-one Base - Manual (Page 20)

38
38
Install the Base Install the Base
39
39
twisted and that both straps lay
fl at across the Belt Path and the
open Lock-Off Clamp (Photo R).
- Pull on the lap portion of the
vehicle seat belt to tighten it on
the Belt Path (Photo S).
- While holding the shoulder
portion of the vehicle seat
belt within the Belt Path, secure
the Lock-Off Clamp fi rmly upon
both straps (Photo T).
Continue on to Step # 8.
7. If using a lap-only vehicle seat belt:
- Open the Lock-Off Clamp
- Thread the lap-only vehicle seat
belt through the Belt Guides
(Photo U).
- Buckle the lap-only vehicle seat
belt
- Make sure the belt is not
twisted and lays fl at across the
Installing the Base: With Vehicle
Seat Belts cont’d
Installing the Base: With Vehicle
Seat Belts cont’d
4. Place the Base in the vehicle seat
(Photo P), making sure the areas
under and behind the Base are clear
of obstructions.
5. If the vehicle seat back is
adjustable, lock the vehicle seat
back into the upright position.
If using a shoulder-lap vehicle belt
to secure the Base, continue to Step
6. If using a lap-only vehicle belt,
skip to Step 7.
6. If using a shoulder-lap vehicle belt:
- Open the Lock-Off Clamp
- Thread the shoulder-lap vehicle
seat belt through the Belt
Guides (Photo Q).
- Buckle the shoulder-lap vehicle
seat belt
- Make sure the belts are not
S
T
U
P
Q
R