Paxton Demonstration Case - TCP/IP - Manual (Page 2)

Connecting to a TCP/IP interface
Install the Net2 software on the PC. Connect the unit to the PC via a Network cable.
Run the Net2 Server Configuration Utility (Start/Programs/Net2) and select TCP/IP nodes.
Click on "Detect" the MAC address of the Ethernet interface will appear in the table. You should then go to the "IP
address configuration" tab and assign the IP address.
You can set up a new IP for the interface but if this is not in the same range as the PC, the device will no longer
respond until you connect to the device with a PC that is in the same IP range.
Some firewall/virus software or other wireless hardware can block the IP detection process. Disable these and try
to detect the interface again. Please contact Technical Support if you require further advice.
*The MAC address can be found on a label in the case and starts 00-xx-xx-xx