PIAA RS400 H.I.D. Shock Lamp - Manual (Page 2)

• When activated, this system operates at extremely high voltage (20,000V).
Do not turn on the switch when holding the cord that connects the ballast and the
lamp!
• Use of damaged or incorrect wiring may cause this product to malfunction and/or cause
an electrical fire.
• Remember that this product operates at extremely high voltages. Make sure your hands
and work area are clean and dry to avoid injury from electrical shock.
• Leave at least 1/8" clearance between the lamps and the front spoiler, as the heat may
damage the spoiler.
WARNING
• This product generates high voltages and is very dangerous. For installation, always
contact one of the PIAA authorized dealers.
• This lamp should only be mounted in the upright position. The PIAA logo should be read
right side up.
• For maximum lamp function, always use the PIAA relay harness (PN 34035).
• Do not disassemble or alter the lamp itself and/or the controller. Also do not open the
cover, disassemble, or alter the relay harness unless the fuse inside the relay unit needs
to be replaced. Overheating, short circuit, or vehicle fire could occur by disassembly or
alteration. We are not responsible for any trouble due to alteration.
• When removing/installing the connector, hold the connector to securely remove/install.
If not securely connected, the lamp will not light up and other problems may occur.
WARNING
2