PIAA RS400 H.I.D. Shock Lamp - Manual (Page 4)

4
• When using a commercially supplied lamp bracket, before removing the bolt
that is already installed on the car body, make sure that it is safe to do so.
• The lamp should be mounted in an area sufficient to support its size and
weight. Failure to do so may result in excess vibration leading to shorter bulb
life and/or physical damage to the lamp or your vehicle.
• Do not attempt to install the lamp directly to any plastic part of the car body.
If the lamp needs to be installed on the plastic, reinforcement materials should
be placed on both sides of the plastic part.
• When installing, make sure the lamp body, lens, and rim are not touching the
bumper and other plastic parts. Such plastic parts might deform.
• The lamp installation surface should be flat.
cAutIoN
2. Using the rubber cushion, flat washer, spring washer, and nut, install the lamp to the car
ensuring the PIAA logo reads right side up.
• The lamp should be tightened to the degree that the lamp body cannot be
moved by hand.
cAutIoN
laMP InstallatIon
1. For lamp installation, a hole with a diameter of
14mm is required. Make necessary preparation
such as installation of lamp bracket.
Flat washer
Spring washer
Nut
Flat washer
Rubber cushion
Spring washer
Nut
Orientation of logo
Tightening Torque: 30N-M