PIAA RS800 H.I.D. Shock Lamp - Manual (Page 2)

1.
• When activated this system operates at extremely high voltage(20,000v).
DO NOT turn on the switch when holding the cord that connects the ballast and
the lamp.
• Use of damaged or incorrect wiring may cause this product to malfunction and or
cause an electrical fire.
• Remember this product operates at extremely high voltage. Make sure your hands
and work area are clean and dry to avoid injury from electrical shock.
• Leave at least 1/8” clearance between the lamps and the front spoiler,
as the heat may damage the spoiler.
• This product generates high voltage and is very dangerous. For installation,
always contact one of the PIAA authorized dealers.
• This Lamp should only being mounted in the upright position PIAA logo should
read right side up.
• For maximum lamp function, always use the PIAA relay harness (P.N.34035).
• Do not disassemble or alter the lamp itself and the controller. Also do not open
the cover, disassemble or alter the relay harness unless the fuse inside the relay
unit needs to be replaced. Overheating, short circuit, or vehicle fire could
occur by disassembly or alteration. We are not responsible for any trouble due
to alteration.
• When removing/installing the connector, hold the connector to securely
remove/install. If not securely connected, the lamp will not light up and other
problems might occur.