PLX Devices DM-200 OBDII - Manual (Page 18)

Users Guide: iMFD User Guide
Version 1.0 Jan 1, 2008
www.plxdevices.com
(408)745-7591
18
must be powered on and toggled to the setup mode “Connect to PC” for successful uploading to occur.
Please refer to the DM-100/200 Programmer users guide included on the CD for details how to upload
your design.
You will need to install the USB device driver (included on the CD) for Windows to properly detect the DM-
200.
5 OBD II Sensors
The DM-200 OBDII in the OBDII Sensors Mode displays sensor information in a page format. To navigate
to this mode, please refer to section (2.4) navigating the menu system. By pressing the “RIGHT” and
“LEFT” button, toggles between the 5 available pages.
Page1:
Sensor Standard Units Metric Units
Throttle Position % %
Engine Speed rev/min rev/min
Vehicle Speed MPH KMH
Engine Load % %
Engine Timing Degrees Degrees
Intake Pressure (MAP) inHG Kpa
Page2:
Sensor Standard Units Metric Units
Air Flow Rate (MAF) LBS/min grams/sec
Fuel System Status Open or Closed Open or Closed
Short Term Fuel Trim Bank1 % %
Long Term Fuel Trim Bank1 % %
Short Term Fuel Trim Bank2 % %
Long Term Fuel Trim Bank2 % %
Page3:
Sensor Standard Units Metric Units
Air Intake Temperature Fahrenheit Celsius
Water Temperature Fahrenheit Celsius
Fuel Pressure PSI Kpa
OBD Type Type Type
Narrowband O2 Sensor Voltage Sensor 1 Bank 1 Volts Volts
Narrowband O2 Sensor Voltage Sensor 2 Bank 1 Volts Volts
Page4:
Sensor Standard Units Metric Units
Narrowband O2 Sensor Voltage Sensor 1 Bank 2 Volts Volts
Narrowband O2 Sensor Voltage Sensor 2 Bank 2 Volts Volts
Ambient Air Temperature Fahrenheit Celsius
Relative Fuel Pressure PSI Kpa
Fuel Level % %
Barometric Pressure inHG Kpa