Precisionsound Hybrid Factory - Manual (Page 6)

6
© Copyright Precisionsound 2011 www.precisionsound.net
The controls for the amplifier, filter and effects are arranged in layers of four knobs. Switches next to
the knobs toggle between the layers.
The tuning knob affects the pitch of the selected Element by up to -25 cents (knob fully left) or +25
cents (knob fully right).
When the stereo width knob is fully left, the selected Element will play in mono. When fully right, a
stereo widening effect is applied.
 If you use the stereo widening effect, consider checking your mix in mono, because the
frequency balance may change when the left and right channels are summed.
The type knob morphs between a low-pass filter (knob fully left) and a high-pass filter (knob fully
right). With the type and cutoff knobs both at mid-point, you have a band-pass filter.
When the envelope strength knob is at mid-point, it does not affect the filter. When turned left, the
envelope has a negative effect on the filter cutoff; turned right, it has a positive effect on the cutoff.
 Take care when using high resonance values, because the filter can self-oscillate and become
loud.
Amplifier
Toggle switch
between layers
Element volume, tuning,
stereo width & pan knobs
Envelope attack, decay,
sustain & release knobs
Filter
Toggle switch
between layers
Filter cutoff, resonance, type
& envelope strength knobs
Filter envelope attack, decay,
sustain & release knobs