2 working with the cutting and grating discs, 3 working with the kneading blade, 8 working with the blender – Bifinett KH 700 User Manual

Page 5

Advertising
background image

9

8

7.2 Working with the cutting and

grating discs

Caution: The cutting edges are very sharp!

Be particularly careful when inserting and

removing or cleaning the discs!

Never use your fingers, spatula, spoon han-

dles or similar objects for pushing foodstuff

through the filling shaft!

With the cutting and grating discs you can

quickly slice or grate ingredients. The special

chip disc allows you to quickly prepare

homemade chips. With the potato pancake

disc you can grate raw potatoes for the

dough but also grate other vegetables or fruit

finely.

• Fit the mixing bowl on

the food processor.

S

• Select the appropriate

disc. Insert the disc

with the guide edge

(the side without mark-

ing) in the disc holder.

• Push the other side

(marked with two circles

at the corners) down

until the disc engages

with a “click”.

• Fit the retainer to the

drive shaft. Insert thumb

and index finger in the

holes of the disc holder

and place it on the

retainer.

• Place the lid on the

bowl.

• You can now fill ingre-

dients through the filling

shaft.

• For cutting and grating

set the speed controller

to speed 3 (maximum

speed). Should you wish to process soft fruit

or vegetables you can also select a lower

speed. Slowly and gradually push the ingre-

dients in the filling shaft using the pusher.

• To remove the disc from

the disc holder, remove

the disc from the disc

holder by pushing on

the marked side in an

upward direction.

Hints:

• Cut the food into pieces so that they fit

through the filling shaft.

• Fill the filling shaft evenly and do not exert

excessive pressure.

• If you wish to process large quantities of

food do it in small batches and empty the

mixing bowl in-between.

7.3 Working with the kneading

blade

With the kneading blade you can knead

bread dough and mix batter or cake mixture.

• Place the mixing bowl

on the food processor.

• Place the kneading

blade on the retainer

and fit on the drive

shaft.

• Add the ingredients to

the mixing bowl.

• Place the lid on the

bowl and the pusher in

the filling shaft. Set the

speed controller to the

speed recommended in

the Table.

Hints:

• Put liquid ingredients into the bowl last and

start mixing at low speed to avoid splash-

ing.

• Never fill the mixing bowl above the MAX.

mark (1.5l).

• For mixing “water like” liquids only use the

speed 1 with volume less than 1 l to avoid

liquid spilling out.

8 Working with the blender

Caution

• Never switch on the blender when empty.

• Never insert the plug in the socket before

the blender jug and the blender lid have

been correctly assembled.

• Always pull the plug from the socket

before removing the blender jug.

• Do not fill ingredients hotter than 80°C in

the blender jug.

• To avoid splashing, never add more than

1.5l of liquid in the blender jug.

• Never remove the blender lid during oper-

ation.

• First remove the blender lid before remov-

ing the blender jug.

• Never run the blender continuously for

more than 3 minutes.

You can use the blender to finely puree and

mix ingredients. You can use the blender for

preparing soups, sauces, milkshakes, baby

food or process vegetables and fruit into a

puree.

• First remove the cover

for the motor block by

turning it clockwise.

KH700_Kuechenmaschine_UK 24.11.2003 13:55 Uhr Seite 11

Advertising