Header operation operating variables (continued) – MacDon 963 Harvest Header User Manual
Page 25
24
HEADER OPERATION
Operating Variables (continued)
REEL SPEED
•
Reel speed affects the smoothness and evenness of the delivered crop. Operating the reel too fast or too
slow relative to ground speed will cause bunching.
•
In standing crop, reel speed should be just faster than ground speed, sweeping crop across the sickle.
•
A faster reel speed may be necessary in leaning or down crop.
•
Excessive shattering of grain heads or crop loss over the header back tube may be indications that reel
speed is too fast.
REEL HEIGHT
•
In standing crop, adjust reel height so bat contacts the plants just below the head, and carries material
through the sickle onto the drapers.
•
Down crop may require a lower reel height to wipe crop off the sickle.
•
Bushy crop may require raising the reel to prevent unevenness in delivery.
•
Indications that reel may be too low are crop loss over the header back tube, or disturbance of crop on the
drapers by the reel bats.
•
For reel clearance to cutterbar adjustment, see Maintenance/Service section, page 49.
REEL POSITION - FORE & AFT
Reel fore-aft position can be adjusted to suit
various crop conditions:
•
For straight standing crop, the reel position is
normally centered above the cutterbar.
•
For crops that are down, tangled, or leaning,
move reel ahead of cutterbar.
•
Disturbance of crop on the drapers by the reel
bats may be an indication that the reel is too
far back.
To adjust reel fore-aft position:
1. Lower reel so support arms are horizontal.
2. Back off jam nut on positioning screw (A) at
each arm.
3. Loosen screw (A) and slide reel mounting
channel (B). Pry bar may be used at hole (C).
4. Tighten screw into selected hole position and
secure with jam nut.
5. Be sure screw is in the same hole at each arm.
6. Check reel clearance to cutterbar. See
Maintenance/Service section.
NOTE: If reel fore-aft position is changed by more
than two holes, check and adjust header flotation.
NOTE: For 36' center arm, positioning screw is on
top of mounting channel. (There is no jam nut on
positioning screw at center arm.)
REEL FORE-AFT POSITION ADJUSTMENT
A
B
C