MacDon R85 Rotary Disc 16 Foot Pull-Type - Manual (Page 114)

OPERATING THE MOWER CONDITIONER
7. Locate feed plate (A) on the disc, ensuring that
hole in feed plate registers on disc. Position plate
approximately as shown and align holes.
IMPORTANT
Feed plate should be located so that when
holes are aligned, the leading edge of the feed
plate (A) is further from the accelerator (B) than
the trailing edge.
Figure 7.29
8. Locate deflector (A) and upper driveline shield (B) onto
feed plate.
9. Raise upper driveline shield (B) into position and move
plates (C) into slots in shield. Do NOT tighten bolts.
10. Insert driveline (D) into deflector (A) and install onto
shaft. Ensure that driveline grease zerks will be
accessible through large opening in deflector.
Figure 7.30
11. Align mounting holes in deflector (B), spindle, and
driveline (D) and reinstall four bolts (A).
12. Torque bolts to 92 ft·lbf (125 N·m).
13. Adjust the upper driveline shield to achieve consistent
gap around deflector shield (C).
Figure 7.31: Clockwise rotation LH
driveline disc
169456
104
Rev. D