MacDon 5020 Mower Conditioner - Manual (Page 74)

74
UNLOADING & ASSEMBLY
ATTACH HYDRAULICS AND ELECTRICAL
5. Attach lights to left and right frame legs as
follows:
a) Insert light support tube through welded tube on
header frame.
NOTE: Left and right lights are different.
Ensure light support tube angles towards rear
of unit with light outboard, as shown.
b) Install one 3/8 NC x ¾ long hex head bolt (B)
and one 3/8 NC hex nut (C).
NOTE: Tighten bolt (B) to secure light firmly.
Do not overtighten bolt. Light must be able to
be turned with minimal force. Lock jam nut (C)
against tube to secure the position.
c) Secure ground wire to frame at (D) with one ¼
NC x 5/8 long hex head bolt, one ¼ external
tooth lock washer (against frame) and one ¼
NC lock nut.
d) Attach wiring harness to light wiring and cover
with plastic harness sheath.
6. Route motor hoses between holders (M) at
support. To avoid damage to hoses, do not
over-tighten holder hardware.
7. Remove top clamp (Y) and place two lift
cylinder hoses and electrical harness across
holder. Replace top clamp (Y) to capture hoses
and harness.
ATTACHING LIGHTS – L/H SHOWN
B
D C
HOSE ROUTING
M
Y