Retsch SR 300 - Manual (Page 13)

2/8/2012

Retsch GmbH
13
0002
Insert 180° grinding insert with frame and sieve insert
Fig. 6
Available as accessories are stainless steel grinding sets, with a frame and
sieve inserts, in a choice of sizes, with Conidur or round perforations.
Fig. 6
Conidur holes 0.08 / 0.12 / 0.20 / 0.25 / 0.50 /
0.75 / 1.0 / 1.25 / 1.5 / 2.0 mm
Round holes 3.0 / 4.0 / 5.0 / 6.0 / 8.0 / 10.0 mm

Unscrew the screws S2.

Remove the ring R1 and insert the ring sieve SI in the groove NU of
ring R2.

Carefully position the ring R1 until the sieve SI slides into the groove
NU.

Screw down the screws S2 and tighten them securely.

Open the door.

Insert the sieve frame with the ring sieve; ring R1 is to the front, ring
R2 to the rear.

The screw heads S3 at the ring R2 must seat in the holes in the mill
housing.

Close the door.
Check to ensure that a collection receptacle is in place.

Start the SR 300.
Starting or stopping the SR 300
Fig. 7
Die SR 300 is started and stopped with the main switch A. Fig. 7

Insert the sieve frame with the ring sieve or grinding set with sieve
insert.

Close the door.

Attach the collection receptacle.
Starting
Turn the knob at switch A to “ON”.
Stopping
Turn the knob at switch A to “OFF”.