Retsch TWISTER - Manual (Page 33)

Fault messages
33
Pos : 11.1 /00005 Ü berschrif ten/ 1. Ü berschrif ten/ 1 F ehler mel dungen @ 2\ mod_1259056589728_9.doc @ 17580 @ @ 1
7 Fault messages
Pos : 11.2 /00010 Bedi enungsanleit ung en Kapitels ammlungen/T wis ter Mill ( 2011) /0035 Z yklon Mill T wis ter F ehler mel dungen/ 3501 Z ykl on Mill T wist er M odul F ehl er mel du ngen @ 3\ mod_1289223018446_9.doc @ 24000 @ @ 1
F01 Motor does not run
F02 Motor switched off because of
excessive load
Restart grinding process with less
feed quantity.
F03 Motor speed too low/high
F04 Hood open
F05 Braking time too high
F06 Motor overheated
Allow the motor to cool down and
restart.
F07 Hood monitoring faulty Check the error message:
Press the START button with the
hood open.
The
“speed” segment display
flashes uniformly.
Close the hood to correct the
fault.
F08 Overspeed caused by hardware
Display
blinkt
Grinding chamber hood is not
closed or grinding chamber cover
has not been fitted
Pos : 12.1 /00010 Bedi enungsanleit ung en Kapitels ammlungen/------- Seit enumbruc h ----------- @ 0\ mod_1222344373758_0. doc @ 2386 @ @ 1