Retsch PT 100 - Manual (Page 23)

Operating the machine
23
Fig. 2: Mounting the vibratory feeder
– The support (HT) is already completely pre-assembled with the stand rod (ST).
• Unscrew the two rubber feet (GF) at the back of the DR100.
• Loosen the hand screw (KN).
• Take the support (HT) off the stand rod (ST).
• Connect the DR 100 and the support (HT) by means of the hexagonal cap
screws and washers (SCH).
Pay attention to the side position of the DR100 vibratory feeder. The position of the
hopper opening varies depending on the dividing head being used.
Fig. 3: Positioning the vibratory feeder
HT
GS
S
GF
KN
SCH
ST
RS