Retsch PT 200 - Manual (Page 19)

Operating the machine
19
Fig. 6: Setting down the device for assembly
After unpacking set down the device on its side only and on a soft and clean
surface (S).
Fig. 7: Fitting the device to the base
Place the rear assembly area (A) of the bottom plate on the frame (F).
Tighten the two screws (S) by hand.
Pos : 6.13 /00005 Ü berschriften/1.1 Ü bersc hriften/1.1 Übersc hriften BD A/11 Ei n- / Aussc hal ten @ 0\mod_1229416527496_9.doc @ 5058 @ @ 1
5.6 Switching On and Off
Pos : 6.14 /00004 Warnhinweis e/W0002 WARNUN G Kabel bruc h Str omstoß @ 2\mod_1278055276120_9.doc @ 20557 @ @ 1
S
F
A
S