Robustel M1000 XP User Guide - Manual (Page 16)

Robustel GoRugged M1000 XP User Guide
RT_UG_M1000 XP_v.1.0.0
19.11.2013 15 / 57
Confidential
2.5 Install SIM Card
Be sure to insert a SIM card before you use the gateway.
Note: A SIM card set with PIN code cannot be used normally in the gateway without the correct PIN code.
Make sure to disconnect the adapter and switch off your gateway before inserting or removing your SIM/USIM card.
 Inserting SIM Card
1. Make sure your adapter is disconnected.
2. Insert the SIM card, and you need press the SIM card with your fingers until you hear “a cracking sound”.
 Removing SIM card
1. Make sure your adapter is disconnected.
2. Press the SIM card until you hear “a cracking sound”, then the SIM card will pop up to be pulled out.
Note:
1. Don’t touch the metal surface of the SIM card in case information in the card is lost or destroyed.
2. Don’t bend or scratch your SIM card. Keep the card away from electricity and magnetism.
3. Make sure to disconnect the power source from your gateway before inserting and removing your SIM card.

2.6 Connect the External Antenna (SMA Type)
Connect this to an external antenna with SMA male connector. Make sure the antenna is for the correct frequency as
your GSM/GPRS/UMTS
operator with impedance of 50ohm, and also connector is secured tightly.