S&S Cycle Billet Air Cleaner Kit PN 106-5131 for Victory Motorcycles - Manual (Page 10)

10
5 – Put the .660” spring clamp over the rubber hose on the air supply line.
6 – Push the rubber piece connected to the air supply line over the brass barb, closest to the throttle body, on the S&S® air cleaner.
7 – Move the spring clamp up over the hose barb as illustrated in Picture 22.
8 – Reconnect the Throttle Position Sensor to the primary wiring harness at the connector.
Breather Hose Routing and Fuel Line Installation
1 – Locate the S&S pre-formed breather hose, straight union fitting, 8” black wire tie, and the three dual wire spring clamps in the air cleaner kit as
illustrated in Picture 23.
2 – The S&S preformed breather hose will need to be cut on both ends for proper fitment. Picture 24 illustrates approximately where the breather
hose should be cut.
Note: It is best to cut long and test fit for proper length and clearance.
Picture 22
Picture 23
Picture 24
Stock Breather Hose
Dual Wire Spring Clamp
Straight Union Fitting
S&S® Breather Hose Dual Wire Spring Clamp
S&S Pre-formed
Breather Hose
1.500"
7.625"