S&S Cycle Billet Air Cleaner Kit PN 106-5131 for Victory Motorcycles User Manual
Page 12
12
Key Switch Cover and Coil Mounting Bracket Installation
1 – Connect the coil and the ignition switch to the primary wiring harness at the connectors. Install the coil mounting bracket back to its original
location, to the front and rear heads, using the socket head cap screws that were removed at disassembly. Tighten fasteners 85 inch pounds.
2 – Connect the spark plug wires back to the coil. Picture 27 illustrates the proper location of the spark plug wires. Front cylinder plug wire
connects to the bottom post on the coil and the rear cylinder plug wire connects to the top post on the coil.
3 – Attach the ignition key switch cover to the mounting bracket from where it was removed.
Throttle Cable and Idle Air Control (IAC) Cover Installation
1 – Connect the throttle cables to the throttle body and adjust following your Victory® service manual.
2 – Attach the IAC cover to the mounting bracket from where it was removed.
Seat and Gas Tank Installation
1 – Install gas tank and seat to the motorcycle you are working on following your Victory service manual.
2 – Connect the negative battery cable lead to the battery that was disconnected prior to the air cleaner installation.
Picture 27