Salsbury Industries 66000 Series Box Style Bridge Lockers - Manual (Page 3)

Box Style Bridge Lockers – Locker Benches
Assembly & Installation Instructions
Thank you for selecting Salsbury’s 77770 series locker aluminum benches. We are confident that the quality and construction of this product will
provide years of maintenance free use.
Preliminary Notes
There are two basic steps to assembly and installation:
1. The bench pedestals must be assembled to the bench top.
2. The bench assembly must be bolted to the floor.
Failure to bolt the bench assembly to the floor could result in
injury to persons sitting on the bench.
Since various types of floors require different types of fasteners, floor
installation hardware is not provided. The hardware provided is for
fastening the bench pedestals to the bench top.
Two bench pedestals are provided for each bench top. Each bench
pedestal should be installed 6” from the end of each side of the
bench top.
Assembly
Install one of the 5/16” by 1-1/4” long carriage bolts through a
straddle clamp and loosely attach it to the bench pedestal with one of
the 5/16” serrated flange nuts as shown in Figure 1. The straddle
clamps should be installed on the end of the bench pedestal with the
smaller plate. Do this with the remaining three straddle clamps in the
first bench pedestal and repeat for the four clamps in the second
bench pedestal.
Set the bench top on a flat surface upside down. Rotate each of the
straddle clamps on a bench pedestal aligned such that they can be
inserted into the bottom of the bench top as shown in Figure 2.
Rotate them each 90 degrees so that they straddle and grip the
inside lips of the bench top when the nuts are tightened as shown in
Figure 3. Ensure that the straddle clamps are aligned with the lips.
Also ensure that the square section of the carriage bolts are inside
the square slots in the straddle clamps. Tighten the nuts until the
clamps are not quite gripping the lips inside the bench top. Slide the
bench pedestal to a position 6” from one end of the bench top.
Adjust the position of the bench pedestal so that it is centered
crosswise under the bench top and tighten the nuts securely.
Repeat for the other bench pedestal, installing it 6” from the other
end of the bench top.
Complete the installation by fastening the assembled bench to
the floor.
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com engineering @ lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 01, 8/25/2010)