Salsbury Industries 33000 Series Designer Lockers Options - Manual

Designer Locker Options - 33000 Series
Installation Instructions
SALSBURY INDUSTRIES
1010 East 62 nd Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com engineering @ lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2012 Salsbury Industries. All rights reserved. 2/20/12 Page 1 of 3
Thank you for selecting Salsbury’s options for designer lockers. These instructions are intended to assist you in assembling various optional items
onto the lockers. Locker fillers may be cut to special sizes for custom installations .
Vertical In-Line Filler and Flat Top In-Line Filler
Install the vertical in-line filler by fastening it to the lockers by
installing screws from inside the lockers into the vertical filler. Install
optional 48” long cleats for greater stability by installing screws from
inside the lockers into the cleats. Install two 12” long cleats 3/4” from
the top edge of the lockers by installing screws from inside the
lockers into the cleats then install one additional cleat at the same
elevation onto the vertical in-line filler. Fasten the flat top in-line filler
to the cleats with liquid nails (or similar product). #8 x 1-1/4” screws
are provided for installation of the vertical filler and cleats.
Vertical In-Line Filler and Sloping Hood In-Line Filler
Install the vertical in-line filler by fastening it to the lockers by
installing screws from inside the lockers into the vertical filler. Install
optional 48” long cleats for greater stability by installing screws from
inside the lockers into the cleats. Install two 12” long cleats 3/4” from
the top edge of the sloping hoods by installing screws into the cleats
and through the sloping hoods then install one additional cleat onto
the vertical in-line filler 3/4” from its top edge. Fasten the sloping
hood in-line filler to the cleats with liquid nails (or similar product).
#8 x 1-1/4” screws are provided for installation of the vertical filler
and cleats.