Salsbury Industries 4350 Mail Chests Pedestal Mounted - Manual

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624-5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering @ mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2011 Salsbury Industries. All rights reserved. (Rev. 01, 11/1/11)
Mail Chests – 4350
Pedestal Mounted Installation Instructions
U.S.P.S. APPROVED
Installing Mail Chest on a Pedestal
Thank you for selecting Salsbury’s 4350 mail chest mailbox.
This instruction sheet is for installing the 4350 mail chest on a
pedestal. Other installation instructions are available for installing the
mail chest on spreaders, mounting a newspaper holder, and
mounting the pedestal in a concrete footing.
When you install a curbside or roadside mailbox, make sure that it is
easily accessible to the mail carrier. By regulation a locked mailbox
should be 41” to 45” from the ground or street surface up to the point
of mail entry. The door should be set back 6” to 8” back from the
front face of the curb or the road edge. However, you should check
with your local postmaster to ensure that the mailbox is installed
according to local regulations. It is important to note that it is not the
responsibility of mail carriers to open mailboxes that are locked,
accept keys for this purpose, or lock mailboxes after delivery of the
mail.
All hardware to install the mail chest is provided with the pedestal.
To install the mail chest, unlock and open the front or rear door of the
mail chest and install four (4) 5/16” - 18 x 2” long pan head bolts
through the four (4) square holes in the inside floor of the mail chest
and through the four (4) tapped holes on the top plate of the
pedestal. Installation is now complete.
Additional hardware provided is not needed and may be discarded.