02_mailchest02_4350_wall_or_column_mounted_rev_01, Mail chest – 4350, Wall or column mounted installation instructions – Salsbury Industries 4350 Mail Chests Pedestal Mounted User Manual

Page 2

Advertising
background image

SALSBURY INDUSTRIES

1010 East 62

nd

Street, Los Angeles, CA 90001-1598

Phone: 1-800-624-5269 Int’l Phone: 323-846-6700

Fax: 1-800-624-5299 Int’l Fax: 323-846-6800

www.mailboxes.com engineering

@

mailboxes.com

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Copyright © 2011 Salsbury Industries. All rights reserved. (Rev. 01, 11/1/11)

Mail Chest – 4350

Wall or Column Mounted Installation Instructions

U.S.P.S. APPROVED






Installing Mail Chest in a Wall or Column

Thank you for selecting Salsbury’s 4350 mail chest mailbox.

This instruction sheet is for installing the 4350 mail chest in a hole in

a wall or column. Other installation instructions are available for

installing the mail chest on a pedestal, installing the mail chest on a
deluxe post, installing the mail chest on spreaders, mounting a

newspaper holder, and mounting a pedestal in a concrete footing.

When you install a curbside or roadside mailbox, make sure that it is
easily accessible to the mail carrier. By regulation a locked mailbox

should be 41” to 45” from the ground or street surface up to the point

of mail entry. The door should be set back 6” to 8” back from the

front face of the curb or the road edge. However, you should check
with your local postmaster to ensure that the mailbox is installed

according to local regulations. It is important to note that it is not the

responsibility of mail carriers to open mailboxes that are locked,

accept keys for this purpose, or lock mailboxes after delivery of the
mail.

It is recommended to have the unit present before starting the wall or

column construction to obtain the best possible installation. The
rough opening should be sized approximately 1/2” larger than the

outside dimensions of the unit.

Due to construction variations and method of fastening the unit in the
installation, the fastening hardware is not included. Choose

fasteners that are appropriate for the construction method. Note:

remove flag from mail chest before installing into column or wall.



Advertising