SATEC RGM180 - Manual (Page 13)

BG0509 REV. A2 13
3. Instrument Setup
The RGM connects to up to 32 devices. Each device has its own
instrument setup definition.
Press Instrument Setup to define
Wiring Setup and Demand Setup, to
adjust the Time, to Reset
measurement parameters and to
define Communication parameters.
Wiring Setup
Press Wiring Setup to define the Wiring Mode, CT primary and Nominal
Frequency.
Press on the value of the desired parameter and enter the correct value.
Press Receive to complete the definition, then close the window using the
X in the upper right corner.
Demand Setup
Power demand parameters can be defined on this screen, used in the
same fashion as the Wiring Setup.
Time Adjustment
Use this screen to set the date and time. Press OK when completed.
Press OK on the ‘Operation successfully completed’ message.
Reset Setup
Use this screen to reset parameters or clear logs. You will be asked after
each operation if you are sure you want to perform the reset.