SATEC RGM180 - Manual (Page 2)

RGM180 QUICKSTART
BG0509 REV. A2 2
LIMITED WARRANTY
The manufacturer offers the customer a 24-month functional warranty on the instrument for faulty
workmanship or parts from date of dispatch from the distributor. In all cases, this warranty is valid for 36
months from the date of production. This warranty is on a return to factory basis.
The manufacturer does not accept liability for any damage caused by instrument malfunction. The
manufacturer accepts no responsibility for the suitability of the instrument to the application for which it was
purchased.
Failure to install, set up or operate the instrument according to the instructions herein will void the warranty.
Only a duly authorized representative of the manufacturer may open your instrument. The unit should only be
opened in a fully anti-static environment. Failure to do so may damage the electronic components and will void
the warranty.
The greatest care has been taken to manufacture and calibrate your instrument. However, these instructions do
not cover all possible contingencies that may arise during installation, operation or maintenance, and all details
and variations of this equipment are not covered by these instructions.
For additional information regarding installation, operation or maintenance of this instrument, contact the
manufacturer or your local representative or distributor.
WARNING
Read the instructions in this manual before performing installation, and take note of the following
precautions:

Ensure that all incoming AC power and other power sources are turned OFF before performing any
work on the instrument. Failure to do so may result in serious or even fatal injury and/or equipment
damage.

Before connecting the instrument to the power source, check the labels on the back of the instrument to
ensure that your instrument is equipped with the appropriate power supply voltage, input voltages and
currents.

Under no circumstances should the instrument be connected to a power source if it is damaged.

To prevent potential fire or shock hazard, do not expose the instrument to rain or moisture.

The secondary of an external current transformer must never be allowed to be open circuit when the
primary is energized. An open circuit can cause high voltages, possibly resulting in equipment damage,
fire and even serious or fatal injury. Ensure that the current transformer wiring is secured using an
external strain relief to reduce mechanical strain on the screw terminals, if necessary.

Only qualified personnel familiar with the instrument and its associated electrical equipment must
perform setup procedures.

Do not open the instrument under any circumstances when it is connected to a power source.

Do not use the instrument for primary protection functions where failure of the device can cause fire,
injury or death. The instrument can only be used for secondary protection if needed.

Read this manual thoroughly before connecting the device to the current carrying circuits.

During operation of the device, hazardous voltages are present on input terminals. Failure to observe
precautions can result in serious or even fatal injury or damage to equipment.
All trademarks are property of their respective owners.
April 2012
Copyright 2003-2007 © SATEC Ltd.