SDC E5 Series Access Control System - Manual (Page 13)

SET TIME ZONE PARAMETERS
Select System
Select Set Reader Parameters (1-2)
Select a reader from the window on the left, and press Edit
Select the Time Zone Table tab (1-2-2)
Use this tab to edit general access and special time zone schedules:
Zone 1-6 : General time zones that set when access is allowed. Zone 1 is usually used as
a 24 hour access time zone.
Zone 7-8 : Special zones that are used to automatically unlock the door for extended
periods of time.
Zone 9 : Special zone used when CARD + PIN is required for access.
Zone 10 : Time period that the Request to Exit input on each reader is active
When you are done, select Save , or Cancel .
P:\Installation Instructions\Access Controls\Inst-E5\INST-E5.vsd Rev C 03-13 Page: 10