Spaulding Lighting RDIC with BOC - Manual (Page 3)

INSTALLATION INSTRUCTIONS - RDIC SHEET 3 OF 4
SAVE THESE INSTRUCTIONS
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000
NOTES:
For replacement LED Assemblies and Drivers please contact Hubbell Lighting for any replacement parts.
Contact your local distributor or agent to confirm parts availability prior to ordering replacement parts.
IMPORTANT: To weatherproof your outdoor installation, be sure to seal all housing (Mounting, Conduit,
Plugs, etc.) with silicone sealant.
INSTALLATION:
1.Remove retaining screws (2) and open the door frame assembly (1).
2.Metal Panel shown in Fig 4 can be repositioned to the opposite side or removed as desired. If
removed the unit will provide both up-light and down-light. If the Metal Panel is not required, loosen the
nuts (7), then rotate the lens clips (6) and remove the panel. Return the clips to the original position and
retighten the nuts.
3.Install the lamp
4.Connect the red and white battery connector. Refer to wiring diagram on page 4.
5.Close the door assembly (1), and tighten the retaining screws (2).
6.Locate the “THIS SIDE UP” label on the back of the unit as a reference for the following steps.
7.Install the provided self-adhesive gasket to the back of the mounting plate (3). Install the mounting
plate (3) on the junction box (Fig1) with screws.
8.Use approved connectors to connect fixture leads to supply leads. Place splices inside the junction
box. Refer to wiring diagram on page 4. A switched and an unswitched circuit is required.
9.Put the fixture on the mounting plate (3), and tighten retaining screws (4), use Silicone around housing
(5) except the bottom of the fixture.
TROUBLE SHOOTER-CHECK LIST
IF LIGHT DOES NOT WORK:
1.Check Your Power Source.
2.Check Electrical Connections.
3.Check To Insure Proper Seating Of Lamp.
4. Check If Lamp Burned Out.
Figure 1 Figure 2 Figure 3
Figure 4
http://www.spauldinglighting.com