Stack-On GC-500-5 4472-0707 - Manual

4472-0707
1 12
R
Home Security Cabinet
Installation Instructions
®
Key #:
Serial #:
MODEL GC-910-5
INSTALLATION OF BARREL RESTS AND SHELF
Installation of Barrel Rests
Measure and mark the locations of the barrel rests on the innner sides of the cabinet using the
dimension shown. (See figure 1)
To install the barrel rests to the cabinet, first remove the backing from the foam rests. For help in
doing this, pinch the end of the foam to help secure the adhesive to the foam.
Attach the barrel rests to the inner sides of the cabinet as shown.
Shelf Assembly
Assemble the shelf inside the cabinet with (4) 10-32 nuts and bolts as shown. (See figure 1)
Place the bottom pad (A) in the bottom of the cabinet.
1
A
36"
CABINET MOUNTING INSTRUCTIONS
Selecting a Location
Your Security Cabinet should be installed in an isolated, dry and secure area.
For greater security the cabinet must be fastened to a solid surface with a minimum space on either side.
Ideally the cabinet would be installed on the side wall of a closet. (See figure 2)
The cabinet should be flat against the wall and floor. Remove the baseboard if necessary. (See figure 3)
Insert the plastic plugs in the cabinet's top mounting holes if you are not installing the Pistol-Ammo cabinet
on the top of the security cabinet.
Wall Mount Option
The (4) mounting holes in the rear of the cabinet must line up with the 16" centers of the wall studs. Drill
new holes in the cabinet if necessary. (See figure 3)
Drill (4) 3/16" pilot holes into the wall studs and secure the cabinet to the wall using (4 ea.) lag bolts and
washers. (See figure 3)
Floor Mount Option
The (4) mounting holes in the rear of the cabinet must line up with the 16" centers of the wall studs. Drill
new holes if necessary. (See figure 3)
Drill (2) 3/16" pilot holes into the wall studs lining up with the top (2) mounting holes in the back of the
cabinet. Secure the cabinet to the wall using (2) lag bolts and washers.
Drill (2) pilot holes and secure the cabinet bottom to the floor with (2) lag bolts and washers.
2
16"
CENTERS
CABINET
TOP VIEW
MINIMUM
3
IMPORTANT:
Record the serial and key numbers from the back of the
cabinet. You will need the serial number information in
order to replace lost keys.
Do not store this document in your security cabinet.
Keep keys in a secure place away from children.
NOTE:
Assemble shelves before mounting the cabinet
to a wall or floor. Exterior access is required for
assembly. Review these instructions prior to installation.
7/16" wrench
Phillips screwdriver
Drill with
3/16" bit
Tools Required: