Before! after, Don’t forget your airaid filter tune-up kit – Stainless Works 450-211 Ford Shelby GT500 2007-09 AIRAID Intake System User Manual
Page 2
16. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses,
bolts, and screws are tight. Double check
the hood clearance!
17. Reconnect the negative battery
cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
Before!
After!
Instructions Revision
Date: 11/18/11
Don’t Forget Your AIRAID Filter Tune-Up Kit!
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is
reusable and should be cleaned using the Airaid Filter Tune-Up Kit periodically.
10. Install the oval hump hose (#4) onto the throttle
body with two provided #80 hose clamps (#9). Leave
the clamps lose for now.
11. Install the Airaid Intake Tube into the oval hump
hose. For ease of installation, don’t tighten the clamps
yet!
12. Slide the Aluminum Spacer (#12) underneath the
CAD and into the hole as shown. Secure the CAD to
the inner fender using the OEM bolt from step #1 and
the supplied 1/4” Fender Washer (#10).
13. Install the Cool Air Dam into the vehicle align-
ing the grommet posts on the bottom of the CAD
into the factory grommets in the fender well. Now
install three 1/4” button head bolts (#6) and flat
washers (#7) thru the CAD and into the Airaid Intake
Tube. Next reinstall the second factory bolt from step
step #6 into it’s respective hole.
14. Install the Airaid Premium Filter (#1) onto the
Airaid Intake Tube and tighten the hose clamp. Next
install the supplied weather strip (#5) onto the top of
the CAD as shown. For ease of installation, start next
to the radiator and work your way towards the fender.
15. Adjust the Airaid Intake Tube for fit and then
tighten the hose clamps on the throttlebody and the
tube. Now reconnect the wiring harness to the MAF,
the breather to the aluminum fitting, and the vacuum
hose to the barbed fitting on the Airaid Intake Tube.