Stainless Works Chevy Camaro V6 2010+ Headers - Manual (Page 2)

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
5. Reinstall (2) rear O2 sensors in lead pipes.
6. If going to factory exhaust complete the following:
a. Reinstall dipstick tube.
b. Reinstall plug wires.
c. Reinstall engine cover.
7. If going to the Stainless Works Exhaust system follow the Catback Installation
Instructions. The reinstall dipstick tube, plug wires and engine cover.
8. Reconnect battery and lower vehicle.
9. Be sure to have adequate clearance around all wires, hoses and lines. If anything
is in contact with the exhaust system, it will melt. Make sure to have at least
½” of clearance and wrap any suspect areas with DEI thermal barrier wrap.
10. After double checking for clearance and making sure all lines, wires and hoses are
secured, drive the car for 10-20 miles and re-check all clamps and clearances.