Stainless Works Dodge Challenger V6 2009-12 Headers - Manual (Page 2)

Installation
1. Apply high temp RTV to headers and install using six 13 mm bolts per header.
2. Install O2 sensors and extensions.
3. Install header outlets, cats (or eliminators) and lead pipes and clamps.
4. Install rear O2’s and extension in left side
5. Install to factory catback or Stainless Works Catback system using supplied
adapters and clamps.
6. Re install service engine cover four 10mm bolts.
7. Re-install air cleaner 10mm bolt and 2 clamps.
8. Be sure to have adequate clearance around all wires, hoses and lines. If anything
is in contact with the exhaust system, it will melt. Make sure to have at least
½” of clearance and wrap any suspect areas with DEI thermal barrier wrap.
9. After double checking for clearance and making sure all lines, wires and hoses are
secured, drive the car for 10-20 miles and re-check all clamps and clearances.
WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183