Buffalo Technology WHR3-G54 - Manual (Page 24)

24
◗
Now that the WHR3-G54 and wireless client adapter are
installed, you can use AOSS to confi gure them.
◗
To begin the confi guration, press the AOSS button on
the side of the WHR3-G54 for 3-5 seconds. The AOSS
light will begin to fl ash when the AOSS mode has been
enabled. You can stop pressing the button at this point.
■ NOTE: AOSS mode will stay active for a period of
two minutes. This is the time-slot required to initiate the
wireless client adapter. The AOSS LED will stop fl ashing
when AOSS mode has stopped or timed out.
◗
Refer to your wireless client adapter's AOSS
supplement to initiate the wireless client adapter's AOSS
mode.
◗
It typically takes 10-15 seconds for the AOSS light to
stop fl ashing after the AOSS button has been pressed
on the wireless client adapter. Once confi guration is
complete, the AOSS light will remain steady. Please
refer to your wireless client adapter's supplement for the
remainder of the setup.
AOSS