Summit BIM70 - Manual (Page 26)

25
5. Mode button: Mainly for service. When this button is pressed, unit can change from Ice
Making mode to Ice Harvest mode, or from Ice Harvest mode to Ice Making mode. You can
judge the mode from the status of the green and yellow LEDs.
6. Ice Size Adjustment Guide:
a. Press and hold the Clean button and the Mode button together for at least 3 seconds. The
unit will enter the Ice Size Adjustment mode. The Ice Making LED (green) will be blinking
continuously during the ice size adjustment.
b. While in the Ice Size Adjustment mode, press the Clean button or the Mode button for the
desired ice size.
Smaller ice setting:
By pressing the Clean button, you can decrease the size of the ice cubes. The Ice Full
LED (red) will flash as you lower the ice size and will finally be blinking at the setting of
smallest ice size.
Larger ice setting:
By pressing the Mode button, you can increase the size of the ice cubes. The Ice Harvest
LED (yellow) will flash as the larger size is set and will blink when the setting of largest ice size
has been reached.
After 10 seconds without any operation, the unit will automatically memorize the current state
and return to the previous mode.
NOTE: If during the ice size adjustment, the Ice Full, Ice Making and Ice Harvest LEDS blink
all at once, this indicates that the unit is in the default factory setting of the ice size adjustment.
7. If the red, green and yellow LEDs are flashing together, the machine is not working. The major
i fuse of the control box has failed. Call for service.
NOTE: Avoid letting water contact the control box.