Summit DW18 Installation Manual - Manual (Page 17)

14
USA
Ø
1/8
" (3,5mm) Ø
1/8
" (3,5mm)
A
B
C
7.3 READJUSTING FOOT LEVELS
Now that the dishwasher is in the cabinet you
must readjust the feet to bring the dishwasher up
to the required height and attach it underneath the
countertop.
1. Readjust the front foot levels with adjusting
wrench to balance the dishwasher and raise it up
under the countertop, make sure the unit is level.
2. Readjust the rear foot levels with a screwdriver
to balance the dishwasher and raise it to the
required height using the brackets supplied.
3. Attach the dishwasher underneath the
countertop with the four screws supplied (Ø 1/8”
x 1/8” - Ø 3.5mm x 14mm). Make sure you do not
go through the top of the countertop or damage
granite.
7.4 ADJUSTING THE MOVABLE TOE KICK
Now that you have successfully installed the dishwasher, you need to
attach the toe kick to the dishwasher. The two piece toe kick can be
adjusted to the height and depth needed for your kitchen. Be sure to
use the slotted toe kick in the front and the other behind it. They slide
into each other.
1. Insert the movable toe kick brackets into the channel ( A ).
2. Make sure that the plastic tab to the left of the “L” opening on the
dishwasher has not closed the channel you will push the bracket
through.
Notice :
Be sure to notice there is a left and a right bracket.
Adjust the toe kick brackets forward or backwards so that they will
align with the kitchen toe kick (
B ).
Notice :
• For model, DW 55100 FBI, note
that you should keep the total
height of the dishwasher at 32 1/4 ”
(819mm) max.