Summit WMC64P Service Manual - Manual (Page 14)

Service manual WM70.C
14
Making a custom programme
Programming
1
Turn the programme selector (J1) to “3 Special”.
2
Start
Stop
Press the Key button (S5) to open the “3 Special” menu.
3
Turn the programme selector (J1) to cycle through the different
options: Pr20, Pr21, Pr22 and Return.
4
Start
Stop
Press the Key button (S5) to open one of the options, Pr20, Pr21
or Pr22. Now you can create your programme by selecting from
the various options and settings.
5
Turn the programme selector (J1) to cycle through the different menus:
-34 Pre wash
-35 Main wash
-36 Rinses
-37 Extra spin
-38 Spin speed
-39 Spin time
Return
6
Start
Stop
Press the Key button to open one of the menus.
7
Turn the programme selector (J1) to cycle through the different
menu options.
8
Start
Stop
Press the Key button to save the setting and return to the
previous menu level. Repeat steps 5 to 8 to program the
remaining settings.
9
Start
Stop
Once you have finished creating the programme, press the Start/
Stop button (S4) to return to the programme menu.
Opening the service menu
Start
Stop +
På/Av If the machine is on: First turn off the power at the main power
switch (S1).
Press and hold the Start/Stop button (S4) while simultaneously
pressing the main power switch (S1).
Start
Stop
× 5 Press the Start/Stop button (S4) 5 times within 5 seconds. The
service menu now opens.
You can make three custom programmes. This is done in the service menu. In order for the new
programme to be made available, one of the existing programmes must be deactivated, that is, set
to “Off”, and the new programme set to “On”. See also the “3 Special” section of the “Service
menu content” chapter.