Summit SNM610C - Manual (Page 7)

• Do not touch a hot oven lamp with a damp cloth. A hot oven light bulb could
burn if touched with a damp cloth. Disconnect the electrical service cord or shut
off the power to the oven before removing and replacing the bulb.
• Allow parts to cool to room temperature before touching or removing them
from the range. When a surface burner is first turned off, the gurner and grate
are hot enough to cause burns.
• Clean the range regularly to keep all parts free of fat or grease which could
catch fire. Pay particular attentionto the area underneath each surface burner,
Exhaust fan ventilating hoods and grease filters should be clean. Do not allow fat
or grease two accumulate. Greasy deposits in the fan could catch fire. Refer to
the hood manufacturer’s instruction’s for cleaning
• Glazed cooking uensils: Only certain types of glass, glass/ceramic, ceramic,
earthenware, or other glazed utensils are suitable for rangetop service without
breaking, due to the sudden change in temperature. Check the manufacturers’s
recommendations for rangetop use.
• Do not place plastic salt and pepper shaker, spoon holders or plastic
wrapping on top of the range. These items could melt or ignite. Potholders,
towel or wooden spoons could catch fire if to if place ti close the flame.
• Do not use a wok equipped with metal ring that extends byond the burner.
Because the ring traps heat, the burner and grate could be damaged. Also, the
burner may not work properly, creating a carbon monoxide level above current
health standards.
• Do not clean the oven door gasket. The door gasket is essential for a good seal.
Care should be taken not to rub, damage or move the gasket.
• Flexible Connetors: If the gas range/oven is connected to a gas supply with a
metalflexible connector, move the oven/range with CAUTION for service or
cleaning. Flexible connectors are not intended for repeated bending. Do not
allow cleaners to make contact with fleible connectors.
The connectors and its fittings are designed for use only on the original
installation and are not to be reused for another appliance or at another
location. Connectors must comply with ANSI Z21 .24.
• It’s good practice for each household to have an appropriate fire
extinguisher for use in the event of a house fire.
• Disconnect the range from the electrical supply before attempting to serve or
move it.
7