Routine cleaning and maintenance – Regency Hampton GC60 Large Pellet Stove OWNER'S MANUAL User Manual

Page 12

Advertising
background image

figure 9: Gc60 Heat exchanger cleaning.

Routine Cleaning and Maintenance

Heat eXcHangeR tubeS (Weekly)
The Heat Exchanger Tube’s Cleaning

Rake Handle is located above the

firebox door. Move the handle all the

way in and out a few times (ONLY

WHEN THE UNIT IS COLD) in order to

clean away any fly ash that may have

collected on the heat exchanger tubes.

As different types of pellets produce

different amounts of ash, cleaning

of the tubes should be done on a

regular basis to enable the unit to run

efficiently.

DOOR GLASS CLEANING (Weekly)
It is recommended that the door glass be cleaned weekly to keep creasote/soot levels to a minimum.

Cleaning of the glass must only be done when stove is cold. Open the door by lifting the handle. The glass

can be cleaned by wiping down the outside and inside of the glass with a dry soft cloth.
If the glass has build up that can not be removed with only the cloth, clean the glass using paper towel

and a gas appliance glass cleaner, this may be purchased through most dealers. If a gas appliance glass

cleaner is not available, use a damp paper towel dipped in fly ash to clean the glass. After the glass has

been cleaned use the dry soft cloth to wipe down the outside and inside of the glass.

ASH PAN AND DOOR GASKETS (Weekly)
After extended use the gasketing may come loose. To repair this, glue the gasketing on using high-

temperature fiberglass gasket glue available from your local dealer. This is important to maintain an

airtight assembly.

ASH BOX (Weekly)
IMPORTANT: The unit must be OFF while the ash pan is removed.
The ash box is located behind the lower door (see Figure 10). To remove the ash box, lift the latch on the

right, open the ash box door, and lift it out.
Dump the ashes into a metal container stored away from combustibles. Monitor the ash level every week.

Remember that different pellet fuels will have different ash contents. Ash content is a good indication of

fuel efficiency and quality. Refer to “S

afety

W

arningS

a

nd

r

ecommendationS

” for disposal of ashes. Vacuum

the inside of the ash pan compartment inside the pedestal including the hole at the top back of the

compartment. Insert the ash box until it makes contact with the ash box stop.
DO NOT PLACE UNBURNED OR RAW PELLET FUEL IN ASH PAN.

EXHAUST VENT (Biannually)
This vent should be cleaned every year or after two tons of pellets. We recommend contacting your

dealer for professional cleaning. To clean the vent pipe, tap lightly on the pipe to dislodge any loose ash.

Open the bottom of the “T” to dump the ash, then vacuum as much of the ash out of the vent pipe as

possible.

FRESH AIR INTAKE (Biannually)
Inspect periodically to be sure that it is not clogged with any foreign materials.

Hampton GC60 Cast Pellet Stove Owner’s Manual

12

Advertising