Regency Energy U32E Medium Gas Insert - Manual (Page 30)

30
U32E-5 FPI Direct Vent Gas Insert
INSTALLATION
12) Plug receiver wire harness wires from the receiver into the DFC
box.
13) Reinstall the DFC box onto the velcro pad on the fl oor of the unit.
14) Install the heat shield to the receiver with two screws and attach
to the fl oor of the unit with a velcro pad.
15) Reverse steps 5 and 4.
16) Match the remote control to the receiver - see remote control
instructions.
17) Reverse steps 2 and 1.
18) Check to ensure there are no gas leaks..
Heat shield
10) Install 4 - AA batteries into the receiver.
Ensure correct polarity.
11) Plug receiver wire harness into the back of the receiver and
bundle wires with the wire clip - as shown below.
Wire clip