TCI HG7 - Manual (Page 29)

P O W E R M O N I T O R P A C K A G E O N L Y
POWER MONITOR OPTION HG7 I, O, & M Manual 27
HG7 “XM” Option Operation
Adjustments
Protection Monitor Settings
♦ The Protection Monitor Setup Parameters and calibration adjustments are factory set and
should not be changed except as directed in the troubleshooting procedures.
♦ The protection monitor is described in detail in the following section of this manual.
Start Up (Commissioning)
Caution Thoroughly check the installation before applying power and operating
the equipment for the first time.
Before Applying Power for the First Time
Inspect the installation to make sure that all equipment has been completely and correctly installed on
accordance with the Installation Guidelines section of this manual.
Before Operating the Drive for the First Time
♦ For units equipped with the HG2 Protection Monitor, check to see that the HG2 operates
as described in the HG2 Power Up Sequence
♦ For units equipped with pilot lights, the Blown Fuse lights should be off. The Filter
Enabled light should be off unless the Enable Input has been jumpered rather than
connected to a Drive Aux Run contact.
♦ Check to see that the cooling fan(s) are operating in units so equipped.