Telematrix SP750 PROGRAMMING - Manual (Page 3)

Programming Voice Mail Dialing
1. Press and hold the “STORE” key for six seconds to activate Administrator mode.
2. Press the “STORE” key multiple times until “VOICE MAIL NO.” is displayed on the LCD screen (figure 1).
3. Enter the voice mail number. The area code is not required if AREA CODE is programmed into memory.
4. Press the “STORE” key to store the voice mail number into the VOICE MAIL memory key.
5. Enter the “PIN NUMBER”, up to 8 digits. The PIN characters will not be displayed (figure 2).
6. Enter the “SECONDS OF WAIT?”, up to 99 seconds (figure 3).
7. To exit the program mode, press “DISC” key or continue to the end of programming by pressing the “STORE” key multi-
ple times until the display reads “All Setup OK”.
Testing the programming……...After programming voice mail, test the program by placing a voice mail into the voice mail
messaging system. Then, wait for the light to illuminate. Press the voice mail button located on the base unit (when in OFF
HOOK position) and it will dial the pre-programmed numbering sequence. The “SECONDS OF WAIT” may need to be
increased if the voice mail was not retrieved. Note: This feature must be turned on by your service provider.
To Program a Phonebook Record Manually
1. Press the “STORE” key. The words “SETUP MONTH:01.” will appear (figure 1).
2. Press the “PHONEBOOK” key. The words “ENTER NUMBER.” will appear (figure 2).
3. Next, press the numbers on the dial pad to enter the number pattern to be stored. It is recommended to enter the local
area code in the numbering sequence. Local area code dialing will not occur when the AREA CODE is programmed into
setup (See your Administrator). Using the keypad, enter the name associated with the number being programmed and in-
clude the Flash, and/or Pause, when needed.
4. Press the “STORE” key again and the display will read “ENTER NAME” (figure 3).
5. Using the dial pad, enter the name of the person to be stored. See the chart on the next page for character entries.
6. After entering the name, press the “STORE” key. The display will read “PLEASE WAIT” (figure 4). The memory function
is now storing the entry. If the record is already in memory, the display will read “REPEAT PHBOOK”.
7. To store another record manually, repeat line item 1 through 6.
Note: To exit the program mode without saving, press the “DISC” key.
Phonebook Programming (Manual Programming of Phonebook Records)
The Spectrum PLUS TM Telephone Phonebook Feature allows for 100 name and number records for frequently dialed calls.
VOICE MAIL NO.
12/01
PM
12:00
555-1212
PIN NUMBER
12/01
PM
12:00
________
SECOND OF WAIT?
12/01
PM
12:00
05
Figure 1 Figure 2 Figure 3 Voice Mail Button
Figure 1 Figure 2 Figure 3
SET UP MONTH:01
12/01 PM 12:00
ENTER NUMBER
12/01 PM 12:00
ENTER NAME
12/01 PM 12:00
05
PLEASE WAIT
12/01
PM
12:00
Figure 4