Telematrix DC640 - Manual (Page 22)

Programming Voice Mail
Using the O ne-Touch Mes saging f ea-
ture, t he V oice M ail a dvanced feature
key c an b e pre ssed to c onnect to the
Voicemail system on the Nortel Meridian
PBX or Central Office switch. The switch
must b e pr ovisioned f or vo ice m ail o n
the 12th key.
The program allows for up to 20-digits.
The di gits o f th e P ersonal Identification
Number (PIN) will appear on the LCD as
they are e ntered, but will not appe ar
after they are saved. The VM Pi n Num-
ber menu will show an aster isk in place
of each digit.
The VM P IN Nu mber Menu will appear
only if t he O ne-Touch Me ssaging fe a-
ture is enabled.
The VM Seconds of Wait menu will also
appear only if the One-Touch Messaging
feature is e nabled. T his is t he a mount
of ti me that the t elephone wai ts whe n
the Vo icemail ke y i s pr essed and wh en
the PIN Number is dialed.
1. Press the “PROGRAM” key (Figure 1). Press
the “UP” or “DOWN” k ey until the display
shows “VM ONE TOUCH MESSAG-
ING?” (Figure 2).
2. To activate, press the “ SELECT” key (Figure
3).
3. Select either “ENABLED” or “DISABLED”. Se-
lecting ENABLE activates One Touch Messag-
ing (Figure 4a, 4b).
Note: If feature key number 12 is provisioned in the
DMS a s t he vo ice ma il key, pressing t he ke y w ill
activate v oicemail regardless i f one-touch m essag-
ing is enabled o r not. However, w hen o ne-touch
messaging is enab led, t he P IN n umber will a lways
be dialed. T he PIN n umber can be left blank (non-
programmed).
4. Press “SAVE” w hen the c orrect default is
displayed.
Save Select Exit
PROGRAM
Figure 1
THEN PRESS
V M O N E T O U C H M E S S A G I N G ?
↓ = P r e v ( S e l e c t ) N e x t = ↑
Figure 2 DISPLAY WILL READ
Save Select Exit
Figure 3 PRESS SELECT KEY
V M O n e T o u c h M e s s a g i n g :
[ E n a b l ed ] ( S a v e )
Figure 4a
Press SAVE or SELECT to continue
V M O n e T o u c h M e s s a g i n g :
[ D i s a b l ed ] ( S a v e )
Figure4b
Press SAVE or SELECT to continue
22