Doorlite glass and frame replacement – Therma-Tru Doors Repair and Replacement User Manual
Page 28
Repair and
Replacement
5.28
2014
SITE 5
Doorlite Glass and Frame Replacement
Apply Glazing Tape (if damaged)
Replace existing foam glazing tape if
damaged. (Part # RPGLZTP)
DO NOT stretch.
Overlap at corners.
Press on lightly with fingers. Then with
a roller tool, fully bond gasket using firm
pressure.
Insert Interior Frame and
Drive Screws with #2
Phillips Bit
Ensure correct alignment of screw
bosses.
Ensure frame edges are well-seated.
Drive screws.
Press-fit screw plugs into frame holes.
Re-hang door.
Position Lite into Opening
Place lite against bottom edge of
cutout to prevent shifting.
Center lite in cutout side-to-side.
Interior side
Exterior lite frame
(half with glass)
NOTE: When installing multiple lites, use a straight edge to
check alignment of lites before securing in place.