Titus TAO IOM - Manual (Page 2)

TAO-IOM-2.1 3-14-14
Step 5:
Mount the floor angle to the floor 6 ¾" away from the
wall with the help of anchor screws (not included). See
Figure 5.
Step 6:
Slide the unit against the wall. Use the slots of the
mounting base to drill hole into the floor angle. Screw
the unit mounting base to the floor angle to secure the
bottom end of the unit as shown in Figure 6.
Step 7:
To secure the top of the unit to the wall place fasteners
(not included) into the drywall as per the dimensions
provided in Figure 7. Screw the unit to the wall with
drywall screw (not included) in four places as shown in
Figure 7.
Step 8:
To remove side accent panel for duct connections
unscrew the panel in five places from the outer side
panel as shown in Figure 8.