Unisteer 8011430 Full Size Ford Rack & Pinion Kit 1957-1959 - Manual (Page 6)

Page 6 656150
10. Using the provided sheet metal screws install the new foam gasket and the left side of the
column plate and snug it. Run a bead of silicone on the overlap seam. Poke a hole for your
speedo cable to go through the gasket and install your speedo cable through the hole on the
right side of the floor plate. Note the hole is slotted in case the attaching nut is bigger than the
hole. You can slide the cable between the slot to put the cable in place. Reconnect the cable.
Install the right side of plate and secure it to the floor using hardware. Note there is a slight
gap at the top right of the plate. You can silicone the gap shut. Make sure the column tube is
in the proper position and slide the clamp you installed earlier over the tabs on the new plate
and tighten clamp in place. Reconnect wiring on column to car and reinstall indicator plate.